34.5″ x 24.75″ x 3/4″ thick End Panel


This is a basic kitchen end panel to be used at the end of a run of cabinets to provide a finished end.

MDF paint grade, $40.00

Maple veneered $50.00

Shop now   

86.375″ x 24.75″ x 3/4″ thick End Panel



This is a basic end panel for a fridge, oven, pantry, or broom closet.

MDF paint grade $80.00

Maple veneered  $90.00

Shop now   

31.75″ x 12.75″ x 3/4″ thick End Panel


An end panel for upper cabinets next to sinks areas, cooktop/hood vents, or at the end of a run of cabinets that needs to be finished.

MDF paint grade, $20.00

Maple veneered, $25.00

Shop now  

34.5″ x 21.375″ x 3/4″ thick End Panel


These are for vanity cabinets that have a shorter depth than a kitchen cabinet.

MDF paint grade, $30.00

Maple veneer,  $38.00

Shop now   

96″ x 4″ x 3/4″ thick Toe Kick


Used for toe kicks below cabinets and also for the larger fillers needed for the cabinets to fit the wall.

Popular paint grade, $32.40

Maple hardwood, $35.40

Shop now   

96″ x 1″ x 3/4″ thick filler


One inch fillers are used next to walls to provide clearance for wall trim and for drawers and doors to open.

Popular paint grade, $8.00

Maple hardwood, $9.00

Shop now  

96″ x 3.25″ x 4″ Crown Molding and Base


A ready to cut to length and install crown molding on a 4″ wide base.  Trim to size and use screws from inside the cabinet or from the top of the cabinet to install. The base is either MDF or veneered maple plywood.

Popular paint grade, $56.00

Maple hardwood $59.00

Shop now   

96″ x 1.25″ x 3/4″ Light Rail

Front view on top, back view on bottom


A small trim strip that is nailed or screwed under the bottom of the hanging wall cabinets to provide cover for any under cabinet lighting.

Paint grade popular, $16.20

Maple hardwood, $18.20

Shop now   

22.5″ x 1.75″ x 1.75″ Pilasters


Used to install pull out trays in base and pantry cabinets.  Provides clearance for the trays so they miss the door hinges and allow vertical adjustment in 1.25″ 32 mm increments.  Four needed for two pullouts or you can cut them in half and use two for an under sink pullout.  They can be stacked for tall pantry cabinets.

MDF paint grade, $8.00 each.

Shop now  

24″ Cabinet Pullout

19.5″ wide x 20.75″ deep x 4″ tall.


Pullouts are about 3″ deep, with metal drawer sides and a 3/4″ thick MDF bottom and drawer back and drawer front.

They are installed on pilasters to allow clearance for the trays to pull out and miss the door hinges.

$38.00

Shop now   

30″ Cabinet Pullout

25.5″ wide x 20.75″ deep x 4″ tall.


Pullouts are about 3″ deep, with metal drawer sides and a 3/4″ thick MDF bottom and drawer back and drawer front.

They are installed on pilasters to allow clearance for the trays to pull out and miss the door hinges.

$50.21

Shop now   

36″ Cabinet Pullout

19.5″ wide x 31.5″ deep x 4″ tall.

Pullouts are about 3″ deep, with metal drawer sides and a 3/4″ thick MDF bottom and drawer back and drawer front.

They are installed on pilasters to allow clearance for the trays to pull out and miss the door hinges.

$61.74

Shop now  

Hang Rail for Upper Cabinets


Screw this to the studs in the wall with the screw line hole 2 5/16″ below where you want the top of the cabinet.  Figure out where the top of the cabinet needs to be, measure down 2 5/16″, run a level line to hang the hang rail.

Use toggle bolts if there is no stud at the last two inches of the rail to ensure that the rail doesn’t pull away from the wall.

$20.00 for a 92″ section.

Shop now   

Save